Cooper 9940 Installationsanleitung PDF herunterladen (Seite 7)

11681330 Issue 1 Page 7

Keypad Addressing

If you have ﬁtted several keypads to one control unit, then each keypad must be

given a separate “address”. Links LK2 to LK4 set the keypad address, as shown

in Figure 4.

BACKLIGHT

Keypad 1

Address

Backlight ON Backlight OFF

ypad 2

ypad 3 Keypad 4

Figure 4. Keypad Addressing.

Keypad Backlight

When supplied from the factory the keypad is conﬁgured with the backlight OFF.

To turn the keypad backlight ON ﬁt the supplied jumper to both pins of the “ON

BACKLIGHT” link, shown in Figure 4.

Connecting Exit Terminate or Panic Buttons

To connect an exit terminate button use the “ET” connector terminals on the

keypad PCB.

Use the “ET” connector terminals to connect a Lock Switch. If using a lock switch

do not connect any other device to the “ET” terminals.

1 2 3 4 5 6 7 8

Keine Kommentare

Cooper 9940 Installationsanleitung Seite 7