Cooper 9448ES Wartungshandbuch PDF herunterladen (Seite 26)

26 496574

The panel beeps twice to show that it has accepted the command. All

the LEDs flash, and the panel is ready for the next command.

The panel gives a single error tone if you enter an incorrect command.

Re-enter the correct command.

3. Key in "99 R" to leave programming mode when you have finished.

You will then be in user mode.

Engineer Program Command List

To change: Key-in: followed by: Notes

Zones omitted in 10 R zone n..n R LEDs ON for zones

Part Set* omitted (see note 1)

Chime 11 R zone n..n R LEDs ON for chime

(EE zone = zone 7)

Zones Not Used 15 R zone n..n R LEDs OFF for zone

not used (see note 2)

Engineer Code 20 R new code R 4 digits

User Code 1 21 R new code R 4 digits (see note 3)

User Code 2 22 R new code R 4 digits (see notes 3 & 4)

Silent Part set 35 R 0 R Audible

1 R Silent

Zone 2 Entry 36 R 0 R Normal Alarm

Route 1 R Entry Route

Auto Re-Arm 40 R 1 R Never rearm

2 R Rearm once

3 R Rearm twice

4 R Rearm three times

5 R Rearm always

Bell Time 42 R 1 R 90 seconds

2 R 3 minutes

3 R 10 minutes

4 R 20 minutes

Entry time 43 R 1 R 10 seconds

2 R 20 seconds

3 R 30 seconds

4 R 45 seconds

5 R 1 minute

Exit time 44 R 1 R 10 seconds

2 R 20 seconds

3 R 30 seconds

4 R 45 seconds

5 R 1 minute

4. Programming

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 59 60

Keine Kommentare

Cooper 9448ES Wartungshandbuch Seite 26