Cooper M3000 Betriebsanweisung PDF herunterladen (Seite 272)

4-22 SPARC Enterprise Mx000 Servers XSCF User’s Guide • December 2010

Caution – IMPORTANT - When the power is turned on from the operator panel, the

air-conditioning time and warm-up time that you set are ignored. If you have set these times

and wish to observe them at startup, perform the poweron(8) command.

4.4.10 Shutdown Wait Time Administration

The shutdown wait time administration is a setting to delay the shutdown start by specifying

the shutdown start time when a power failure has occurred in the system with the UPS.

■ Command operation

1. Use the showshutdowndelay(8) command to display the shutdown wait time.

2. Use the setshutdowndelay(8) command to set the shutdown wait time. Set the

shutdown wait time from 0 to 9999 (sec). The default is "10 sec."

4.4.11 Dual Power Feed Administration

The dual power feed is a type of power feed for high-reliability systems that contain dual

lines to the power supply. If one line stops, the other line does not stop and enables the

system to continue operation. This capability can be enabled or disabled using an XSCF

Shell command. This setting is done by FEs.

Note – The ability to enable and disable the dual power feed or display its current status is

available on M3000/M4000/M5000 servers only. However, the dual power feed mode cannot

be used with 100V power on M4000/M5000 servers. When the optional power cabinet for

dual power feed is connected on M8000/M9000 servers, it automatically configures the dual

power feed mode. For details about the setting the dual power feed, see the Installation

Guide for your server.

XSCF> showshutdowndelay

UPS shutdown wait time : 500 second(s)

<Example> The shutdown wait time is set to 600 sec.

XSCF> setshutdowndelay -s 600

1 2 ... 267 268 269 270 271 272 273 274 275 276 277 ... 431 432

Keine Kommentare

Cooper M3000 Betriebsanweisung Seite 272