Cooper M3000 Betriebsanweisung PDF herunterladen (Seite 405)

Appendix D Troubleshooting D-5

Alert Message is Displayed in XSCF Web

■ Please confirm the content of the security alert message and stop the use of XSCF Web.

Perform the countermeasure to the content of the confirmed warning. When the expiration

is over, re-set the https setting of XSCF. For the details of settings, see Section 2.2.8,

“Https Administration” on page 2-109 in Chapter 2.

Other Problems

Contact the system administrator. If XSCF log data must be collected, use the XSCF Shell

command to collect it. For information about the log collection method, see Section 8.2,

“Collecting XSCF Logs” on page 8-22.

Frequently Asked Questions (FAQ)

Q. Is an IP address assigned by default to the LAN port used for the XSCF-LAN?

A. An IP address is not assigned by default. If an IP address were assigned by default, one IP

address would be temporarily duplicated during the concurrent setup of multiple units. This

may affect the user LAN environment. To prevent this, the XSCF-LAN network function is

disabled by default. However, there is a default value for the IP address for the network

connecting redundantly configured XSCF Units (ISN). For information about the default

value, see Section 2.2.1, “Network Configuration” on page 2-16 in Chapter 2.

Q. If an Oracle Solaris OS hang-up event occurs during Oracle Solaris OS startup after the

main unit is powered on, can the main unit power be turned off?

A. If an Oracle Solaris OS hang-up event occurs, the first action is to do the following

instead of turning off the main unit power:

1. First, execute the reset(8) command with the panic option from the XSCF Shell.

2. After doing Step 1, if the Oracle Solaris OS dump fails, move to the ok prompt by

executing "Break", or executing the reset(8) command with the xir option from the

XSCF Shell. At this point, execute the "sync" command.

3. After doing Step 2, if the reset operation or the "sync" command fails, execute the

reset(8) command with the "por" option from the XSCF Shell, or forcibly turn off

power by using any of the following methods:

Method 1. Press and hold down the POWER switch on the operator panel of the main unit

for four seconds.

Method 2. Execute the poweroff(8) command from the XSCF Shell.

Q. What kind of processing is executed by XSCF from the time that input power to the main

unit is turned on until the Oracle Solaris OS starts?

1 2 ... 400 401 402 403 404 405 406 407 408 409 410 ... 431 432

Keine Kommentare

Cooper M3000 Betriebsanweisung Seite 405