Cooper TS690 Installationshandbuch PDF herunterladen (Seite 17)

Wiring a Biscuit to a Panic Button

The figure below shows typical wiring configuration

for a standard panic button.

Wiring a Biscuit to a Smoke Detector

The figure below shows typical wiring configuration

for a standard 12V smoke detector.

External Sounder Connections

The following terminals have been provided to

allow connections to an external sounder:

H/O - This is used to provide a permanent -ve

hold off to external sounders, strobes etc.

H/O + This is used to provide a permanent +ve

hold off to external sounders, strobes etc.

It is protected by a 1 Amp fuse (Bell 12V).

TR - This is the negative tamper return

connection from the siren or bell.

STB - This is the strobe output which will switch to

0V on alarm and is rated at 500mA.

Connect the other side of the strobe to the

H/O +.

TRG - This is the bell trigger output which can be

programmed for SAB or SCB operation, as

follows:

SAB: TRG - will switch to 0V on alarm and

will provide a maximum of 500mA.

SCB: TRG - will provide a negative hold

off (500mA), which is removed on alarm.

Auxiliary Tamper

These two terminals provide tamper protection to

auxiliary devices such as power supplies,

extension loudspeakers etc. If they are not used

they must be linked out.

TS690 & TS690ID Installation Manual System Installation

Blue

Yellow

White

Blue

Figure 17. Wiring a Biscuit to a Panic Button

+- SPARE ALARM

Red

Black

Yellow

Blue

White

Blue

Yellow

Figure 18. Wiring a Biscuit to a Smoke Detector

Typical

External Sounder

Control

Panel

H/O +

12V +

H/O -

Tamper In

TR -

STB -

Tamper Out

TRG -

Strobe +ve

Strobe -ve

Trigger -ve

Figure 19. External Sounder Connections

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Cooper TS690 Installationshandbuch Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Cooper TS690