Cooper TS690 Installationshandbuch PDF herunterladen (Seite 9)

Control Panel Installation

Proceed as follows:

1. Open the control panel by removing two

screws from the front cover. Remove the cover

and disconnect the earth bonding cable from

the spade connection near the transformer.

2. Note the position of the cable entries as

follows:

(a) Ten 20mm cable entries for detection,

alarm and remote keypad cables.

(b) A 20mm cable entry for mains (240V)

below the mains input terminal block.

The mains cable must enter the control

panel through its own cable entry and

must not be mixed with other cables.

3. Hold the control panel back box in the

required position and mark the centre of the

middle fixing position. Remove the back box,

drill and plug the hole.

4. Screw a No 10 screw into the plugged hole.

Reposition the back box and mark the

remaining two securing holes. Remove the

back box, drill and plug the holes.

5. Reposition the back box and pass all cables

into the base via the appropriate cable entries,

remembering to fit grommets where

necessary.

6. Secure the back box using not less than 30mm

x No 10 screws through the three securing

holes.

7. If required install and connect the following:

(a) Stand alone digicom or RedCARE STU.

(b) Printer type DATAC or serial RS232 via a

printer adapter (MPA/DCI).

(c) Relay module type RM.3A.

When replacing the cover, always

ensure that the earth bonding lead is

connected to the spade connection on

the transformer.

9

TS690 & TS690ID Installation Manual System Installation

Mains

Transformer

Spade connection

for earth lead to

front cover

Mains Cable

Entry

Fused Terminal

Block 315mA

Printed Circuit Board

(PCB)

Battery

Position

Figure 4. TS690 & TS690ID Control Panel Layout

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare