Cooper TS690 Installationshandbuch PDF herunterladen (Seite 30)

[7] Inverted - Inverts the operation of the

keyswitch.

If the “Keyswitch” is not assigned to any of the

above options, the circuit becomes a

“Monitored” circuit. A “Monitored” circuit is

monitored at all times. When triggered it will

activate any outputs that are programmed as

Timed Output and log the event.

Circuit Attributes

Each circuit type can have one or more attributes

assigned to it to alter its operation. The following

circuit attributes can be programmed:

1 Access

Circuits programmed with this attribute are

automatically isolated during the entry

procedure to allow a “walk through” route for

the user to access the remote keypad. The

“Access” attribute can only be assigned to

Night and Final Exit circuit types.

2 Double Knock

Circuits programmed with this attribute will only

cause an alarm condition if:

a) The circuit is activated twice within the

Double Knock window (this time may be set in

the System Timers menu).

b) The circuit remains active for the whole

duration of the Double Knock window. The

“Double Knock” attribute can only be assigned

to Night, 24hr, PA and Auxiliary circuit types.

3 Test

Circuits with this attribute will be disabled from

the system for the period set by the “Test Time”

(see System Timers). If the circuit is activated

during this period the activation will be logged

and the user is informed of the circuit failure

when trying to set the system. The test fail

message may only be cleared with the

Engineers passcode. If at the end of the test

period no activations have occurred the

circuit is automatically removed from test and

behaves as normal. The test period is initiated

by entering the Engineers passcode. The “Test”

attribute can only be assigned to Night, 24hr,

PA Silent, PA Audible, Fire, Auxiliary, and circuit

types.

4 Omittable

Circuits with this attribute are allowed to be

omitted by the user when setting the system.

The “Omit” attribute can only be assigned to

Night, 24hr, and Auxiliary circuit types.

5 Reset

This attribute is normally assigned to a circuit

that is connected to a vibration or smoke

detector, so that during the “Detector Reset”

period the circuit is not monitored. The “Reset”

attribute can only be assigned to Night, 24hr,

Fire and Auxiliary circuit types.

6 Monitored

Circuits with this attribute will activate the

"Timed Output" when triggered. The

“Monitored” attribute can only be assigned to

Night, 24hr, Fire, Auxiliary and Final Exit circuit

types.

7 Entry

Circuits with this attribute will initiate the entry

procedure when the system is part-set and

respond as normal when full set. This attribute

must be assigned to all circuits that are

required to initiate the entry procedure in the

part-set condition. The “Entry” attribute can

only be assigned to Night, 24hr and Final Exit

circuit types. When assigned to a 24 Hour

circuit type, the circuit can be used to initiate

the entry procedure. Once the system is unset

the 24 hour will revert to normal operation.

8 Chime

Circuits with this attribute will cause the internal

sounders and remote keypad sounders to

generate a two tone “chime” sound if the

circuit is activated. The “chime” attribute may

only be assigned to Night, 24hr, Auxiliary, Final

Exit and Exit Terminator circuit types.

Engineer’s Menu 1 TS690 & TS690ID Installation Manual

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Cooper TS690 Installationshandbuch Seite 30

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Cooper TS690